Preparation - CommScope NOVUX NVX-CR-DU-FL-NN Instructions D'installation

4 Prepare two drop cables
N.°
1 Jacket
2 Dual jacket (if present)
3 Aramid yarn
4 Subunits
5 Rigid strength member (if present) Remove the rigid strength member.
1
6,5 cm
1 Use the strip silicone tape provided in the kit: 6,5 X 1,25 cm / 2.56 X 0.5 Inches.
Avertissement :
Make sure your hands are clean and degreased before preparing and installing the cables.
Degrease the cables where the cable will enter the closure.
2 Position the cable on the cable support: The end of the sheath must be aligned with the rib (Figure 2). Make a mark
on the top and bottom cable as indicated. Alternatively the mark can be applied 2 cm / 0.79 Inches from the jacket
end.
3 Apply the silicone tape between the mark and the jacket end. Remove the protective paper. Stretch the tape
minimum 50% while wrapping the tape around the cable. First apply a full turn around the cable, then continue to
cover up to the jacket end. Make one turn at the end point and come back with the remaining tape.
1
Description
2
© 2022 CommScope, Inc. All Rights Reserved
2
4
Avertissement : The distance of the jacket that should be
removed is depending on the closure where the cable reten-
tion is installed. Distances below are valid for cable stubs:
• CC 100: 130 ±5 cm / 51 ±2 Inches
• CC 150: 135 ±2,5 cm / 53 ±1 Inch
• CC 200: 135 ±2,5 cm / 53 ±1 Inch
• SRC 100: 90 ±5 cm / 35 ±2 Inches
• SRC 50: 130 ±5 cm / 51 ±2 Inches
Make the dual jacket as small as possible; keep a maximum length
of 1,2 cm / 0.47 Inches. Remove the aramid yarn inside this second
jacket.
Cut the aramid yarn to length to 12 ±1cm / 4.7 ±0.2 Inches. Limit
the amount of aramid yarn.
Clean the subunits, remove all grease. The subunit tube should be
removed to access the fiber.
Avertissement : Stripping point of the subunit is provided in
the closure installation instructions.
2 cm
2 cm
la page 2 / 7
12 cm
3

Preparation

É
É
É