Premise CS2 Serie Instructions D'installation page 2

INSTALLATION OPTIONS
Our Commercial Linear Strip can be installed via Chain MounJng with V-
Hook, Surface MounJng, or T-Bar Clip (all sold separately).
GENERAL WIRING DIAGRAM
TO INSTALL FIXTURE
NOTE: Always turn off the power supply from main circuit breaker before beginning.
1. Remove the new LED fixture from packaging and inspect for any damages. Handle
new LED fixture with care.
2. Connect the LED fixture to line wire, black to black, white to white and green to
green. Use only UL listed wiring.
3. Mount fixture according to your requirement: chain mount with V-hook, surface
mount, or T-bar clip mount.
4. For chain mounJng, aeach customer supplied V-hooks to each end of the luminaire
base. Aeach customer supplied chain to the V-hooks and mounJng surface.
5. For surface mounJng, secure luminaire base to mounJng surface by inserJng
customer supplied #8 anchor screws, toggle bolts or suitable fasteners depending on
structural condiJons into the key hold slots on the top side of the luminaire base.
6. For T-bar clip mounJng, aeach customer supplied T-bar clips to the designated
opening on the luminaire. Bring luminaire into T-bar ceiling grid and secure luminaire
to grid.
2