Battery Installation; Keypad Functions - GGM gastro WG5-A Mode D'emploi

SW
1 INTRODUCTION
▪ Loaded measurement component equipped with high accuracy load-cell.
▪ Large liquid crystal display .
▪ Operating temperature: 15-30ºC
▪ Quick display of weight.
▪ Auto power off to conserve battery power.
▪ Auto calibration via keypad.
▪ TARE function.
▪ Low battery indication.
▪ Overload indication.
▪ Multi-function on weighing and parts counting.

2 BATTERY INSTALLATION

Battery specification: C size (LR14) x 3 pieces not included.
Installation procedure:
1. Remove battery cover from the compartment under the scale.
2. Install batteries with correct polarity.
3. Close battery cover.
3 OPERATION

3.1 KEYPAD FUNCTIONS

Press this key to turn the scale on and off.
When the scale is turned on, LCD shows as figure below and
auto zero after 3 seconds.
Use this key to switch the weight unit such as kg, lb, oz or pcs.
1. Press this key to proceed tare & zero function when power is
on. (You can use tare function to eliminate container weight,
then you can net weight when a container is used)
2. When power is off, press this key for 3 seconds to go into
calibration procedure.
Counting function:
1. When the power is on, press
2. Press
ces. * The larger the sample size, the more accurate unit weight
registered.
3. Based on the size selected, place the selected number of sam-
ple pieces on the platform.
to select sample size of 10, 20, 50, 100 and 200 pie-
to select unit in "pcs".
ES / EN /FR / IT / DE