Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
INSTALLATION INSTRUCTIONS-
PILOT LIGHT ACCESSORY KITS
Accessory kit installations should be performed by a qualified electrician.
Risk of electric shock. Disconnect all power supplies before working on equipment.
1. Remove 1/2" single knockout located in front face of cabinet. Reference figure below for location.
2. Install pilot light body into the open hole created in step (1).
3. Connect pilot light lead wires to the control wiring board screws marked "C" and "C1". Torque screws to 12 in-lb (1.4
Nm).
4. Install "Heater On" label to the front cabinet face directly above the pilot light lens.
240 Series Electric Unit Heater
WARNING
Control Voltage Rating
Kit Item
(Reference heater nameplate)
HX-1024168
HX-1024169
24 Vac
120 Vac
HX24-2239-83-1EF
Publicité
Manuels Connexes pour Heatrex 240 Serie
Sommaire des Matières pour Heatrex 240 Serie
- Page 1 INSTALLATION INSTRUCTIONS- PILOT LIGHT ACCESSORY KITS 240 Series Electric Unit Heater WARNING Accessory kit installations should be performed by a qualified electrician. Risk of electric shock. Disconnect all power supplies before working on equipment. Control Voltage Rating Kit Item (Reference heater nameplate) HX-1024168 24 Vac HX-1024169...
- Page 2 Instructions d’installation pour l’accessoire des necessaires de lampe témoin pour les appareils de chauffage électriques série UHIR AVERTISSEMENT Les installations des necessaries d‘accessoires doivent être executées par un électricien qualifié.Danger de choque électrique.Débrancher toute alimentation électrique avant de modifier l’équipement. Characteristique nominale de Kit Item la tension de contrôle (voir la...