Beper P302VIS050 Mode D'emploi page 7

LED Light Mirror Use Instructions
This appliance is for household use only.
To protect against electric shock, do not immerse cord, plug or any
parts of the appliance into water or other fluids.
Do not use the appliance near explosives, highly flammable mate-
rials, gases or burning flames.
Do not allow children, disabled people or every pe-
ople without experience or technical ability to use
the appliance if they are not properly watched over.
Close supervision is necessary when any appliance
used by or near children.
Product description Fig.A
1. Main unit
2. Organizer base
3. Main switch
4. Battery case
5. USB cable inlet
6. LED lights ON/OFF key
7. LED lights
8. USB cable
Warnings for use
Keep this manual for any future reference.
Remove all packaging materials before using the item, and make sure to keep these materials out of the reach
of children and pets.
Do not use the item in case of malfunctioning, or in case of accidental drops/damages, or if it has been immersed
in water or other liquids.
Do not attempt to repair/modify the item in any way.
Do not use this item where aerosol (spray) products are used or where oxygen is administered.
Do not use this appliance outdoors and do not expose it to atmospheric agents.
Important: the side mirrors with magnifying effect may show a slight curvature, due to the specific
processing carried out on the glass; this curvature is normal, and it is not to be considered a defect
of the product.
Assembling and operation
After removing all packaging materials, insert the main unit inside the dedicated hole found on the organizer
base, applying a light pressure.
Place the assembled mirror on a flat and stable surface. The tilt of the mirror can be adjusted up to 180°, while
its rotation can be adjusted by 90° towards left or right.
This mirror can be operated with 4 type AAA batteries (not included), or connected to the mains source via the
USB cable provided. In case of battery operation, open the battery case at the back and insert the batteries, fol-
lowing the polarity indicated. In case of USB operation, insert the cable inside the inlet at the back, and connect
USB plug to a USB port.
Warning: remove batteries when the mirror is connected to a USB port, or in case it is not used for
long periods of time.
To activate LED lights, first of all place the main switch on I (ON), then press the ON/OFF key found at the center
of the mirror. To switch the lights off, press the ON/OFF key again.
Once done using, place the main switch on O (OFF), and, if applicable, unplug the USB cable.
7
EN