Topmodel XPower RS810 Mode D'emploi page 2

Installing the RS810 Receiver
1. Plug in crystal.
2. Plug in all the servos/ESC. Pay attention to the polarity of
the wire. Please consult to the labels of the channel number
and polarity on the case.
Caution: If the polarity of the plug is wrong, it will
damage the servos/ESC.
3. Plug battery/switch harness into any unused channel. If
channel is not enough, you can use Y harness to connect bat-
tery and servo to one channel.
4. Wrap receiver in foam rubber to isolate it from vibration.
5. Secure the receiver in aircraft with rubber band or Velcro.
6. Unwind the antenna. Please do not snip the antenna.
Range checking
Quick range checking
Fully collapse the antenna of the transmitter, and move the
transmitter sticks ceaselessly. You can ask someone to watch
the receiver whether it has lost the control. If the aircraft lo-
ses the signal when you are 45m (150') away from it, it pas-
ses the quick range checking.
Rigorous range checking
Affected by the environment greatly, the quick range checking
cannot refl ect the actual range correctly. If you suspect range
problems, please take the rigorous range checking.
1. Place the receiver on a non-metallic surface (for example, a
wooden pew) which is at least 2 feet (60cm) off the ground.
2. Fully extend the antenna of the receiver and fi x it vertically.
Don't let it touch the ground.
3. Connect one servo to channel 1.
4. Fully extend the antenna of the transmitter.
5. Turn on the transmitter and then turn on the receiver.
6. Walk away from the receiver while moving the transmitter
sticks ceaselessly. Ask someone watch the servo and note any
loss of control.
Caution: The range is susceptible to the power of the trans-
mitter, so please use a new battery. The range will be affect by
the environment, so the range checking must be taken in the
open fi eld. The range tested in the air will larger than that on
the ground, so we suggest you guarantee the range according
to the range checking on the ground.
Sketch map
RS810
FM 8CH RECEIVER
SINGLE CONVERSION
BP3- Le jardin d'entreprises de SOLOGNE - F-41300 SELLES SAINT DENIS - www.topmodel.fr
8
by
7
6
5
4
3
2
1
TOPMODEL S.A.S.
Distribué par/Distributed by:
©TOPMODEL 2006