PILA BP Serie Directives D'installation

LED PANEL LIGHT
BP Series LED Panel
CAUTION: Do not use or store in corrosive environment with CAUTION: Turn o the electrical power at the fuse or circuit
hazardous material e.g. Sulphur, Chlorine, Phthalates, etc. breaker box before installing or servicing any part of this xture.
CAUTION: The installation and servicing of this product should be
performed by a quali ed electrician or service personnel.
PLANNING INSTALLATION
• Turn o the electrical power at the fuse or circuit breaker box before installing or servicing any part of this xture.
• Carefully remove the xture from the carton and check to make sure that all parts are included.
Be careful not to misplace any of the screws or parts needed for installing the xture.
INSTALLATION
1 . Luminaires shall be installed, dismantled and maintained by quali ed electricians.
2. Before installation, check the construction structure and material of the installation location to ensure that it is reliable,
and can support the weight of luminaire, and then complete the installation.
3. The selection of power supply wire and the installation of line must comply with IEE electrical standards and national
standards. Do not electrify during the wiring process.
4. The installation steps are on the following pages:
14/08/2019 Page 1
LED PANEL LIGHT
BP Series LED Panel
5.1 5.2
• Remove the ceiling tile at the installation and adjacent • Tilt the luminaire into the ceiling grid as shown in
positions of the panel light FIG. 5.21, and then in the direction as shown in FIG. 5.22,
put it into the ceiling grid and nish it as shown in FIG. 5.23
FIG.5.21
FIG. 5.22
FIG.5.23
5.3 5.4
• After putting the luminaire into the ceiling grid, twist • Power should be turned o before wiring
the four shock-proof hooks on the panel light to the
t-bar as shown in the gure.
14/08/2019 Page 2
5.5
• After the installation of the luminaire, loosen the screw and take out
the power cover, connect the mains power leads in the hose with the
wiring terminal on the power cover, and connect the wiring according
to the marking on the wiring terminal：
Connect the black wire from power source to the terminal marked 'L'.
Connect the white wire from power source to the terminal marked 'N'
Connect the yellow/green wire from power source to the terminal
marked'GND'.
If you need dimming, connect the low voltage leads to the dimming
terminals on the driver.as shown in the gure:
Connect the purple wire from power source to the xture and wrap up
with insulated rubber tape.
Connect the gray wire from power source to the xture and wrap up
with insulated rubber tape.
Then x the Power cover with screw.
CARE AND MAINTENANCE
OFF
Caution: Before attempting to clean the xture, disconnect the power to the xture by turning the breaker o or removing the fuse from the fuse box.
This LED light xture is made from quality materials that will last many years with minimum care and maintenance.
.
You may want to clean the xture with a soft cloth periodically To maintain the best appearance of the xture, do not use cleaners with chemicals,
solvents or harsh abrasivers. Do not use liquid cleaner on the LEDs, LED driver, or wiring inside the light xture.
14/08/2019 Page 3
LED PANEL LIGHT
BP Series LED Panel
5.6
• After the wiring is completed, return the cover plate near
the luminaire to the original position and the installation
is completed, as shown in the gure.Turn on the power
switch and check whether the luminaire is working properly.
Read All Instructions. SAVE THESE INSTRUCTIONS