Little Seeds 6801015COM Manuel D'assemblage page 27

6801015COM
3 Drawer Dresser
Step 19
IMPORTANT: THIS UNIT MUST BE SECURE TO THE WALL TO HELP PREVENT TIPOVER.
FOLLOW THESE INSTRUCTIONS TO INSTALL THE ANTI-TIPPING SAFETY BRACKET PROVIDED
WITH THIS PRODUCT.
WARNING
Serious or fatal crushing injuries
can occur from furniture tipover.
To prevent tipover:
* Install tipover restraint provided
* place heaviest items in the
lowest drawers
* Unless specifically designed to
accomodate, do not set TVs or
other heavy objects on the top of
this product
* Never allow children to climb or hang on drawers,
door, or shelves
* Never open more than one drawer at a time
Use of tipover restarints may only reduce, but not
eliminate the risk of tipover.
OPTION 1: Attachment into a wall stud (preferred method)
Using a stud finder, locate a stud in the wall. Place your unit against the wall, with the safety
bracket aligned in this location. To make driving the screw easier, you can drill a 1/8" diameter
pilot hole (3mm) through the safety bracket into the stud. Drive the screw through the safety
bracket into the wall stud. Tighten the screw that was not fully tighened in step 1.
OPTION 2: Attachment into drywall
Locate your unit where desired against a wall and mark the wall through the safety bracket,
then move your unit aside. Drill a 3/16" diameter hole (5mm) into the wallboard. Tap the wall
anchor into the hole until it is flush. Move your unit into location and fasten the wall bracket to
the wall anchor with the screw. Tighten the screw that was not fully tightened in step 1.
littleseedskids.com
11c
11d
x1
#A84050
27
For Masonry, Concrete, or
other wall materials:
Consult your local hardware
store for appropriate anchors
to securely attach the safety
bracket.
hole
11d
wallboard
11c
stud