Installation - Signature Design by Ashley P655-772 Guide D'utilisateur

1. Check that the control knob for the gas
supply system is turned to the "OFF"
position before starting any assembly.
2. Remove the burner cover(F) from
body(C).
Note: Cover must be removed when burner is in operation.
3. Remove door(E) from body(C) and place the
propane gas tank (not included) into the tank holder.
Tighten the preassembled wing screw clockwise to
ensure the propane tank is secure. Replace the door
(E) after the tank is connected to the regulator (see
below).
P655-772

INSTALLATION

Page 9 of 43