Premise WP2 Serie Instructions D'installation page 2

INSTALLATION STEPS
FIGURE 1
FIGURE 2
1. Disconnect the power by turning off the circuit
breaker. Loosen both outer side screws of the
fixture, open the housing, and then loosen both
inner side screws.
2. Expose the supply wires from the J-box. Mount
the mounGng box to the J-box with the
supplied screws, gently pull the supply wires
through the hole in the back housing, then
connect the black supply wire to the black/
brown fixture wire. Secure with the supplied
wire nuts. Next, connect the white supply wires
to the white/blue fixture wire and secure with
the supplied wire nuts. Wrap the green wire
around one of the protruding screw or connect
it to the supply ground wire. Secure all wires
with electrical tape (not supplied) and tuck into
the mounGng box. (Figure 1).
3. Tighten the inner side screws, close the
housing, then Gghten the outer side screws.
(Figure 2).
4. Restore the electricity and check the operaGon
of the new wall pack fixture.
NOTE: This fixture is wet locaGon rated. In order to
ensure that moisture does not enter the outlet box
and cause a short circuit, clear caulking should be
used to seal the space between the fixture
mounGng bracket and the wall. Ensure that a space
is lef at the bogom to allow for the escape of
moisture. It is recommended that outdoor silicon
sealant be used for that purpose.
2