Zbeamz 153.750 Mode D'emploi page 3

USER MANUAL
1. Introduction
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle could harm the
environment. Do not dispose of the unit (or batteries) as unsorted municipal waste; it should be taken to a
specialized company for recycling. This device should be returned to your distributor or to a local recycling
service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing this product! Please read the manual thoroughly before bringing this device into service. If
the device was damaged in transit, don't install or use it and contact your dealer.
2. Safety Instructions
Keep this device away from children and unauthorized users. There are no user-serviceable parts inside the
device. Refer to an authorized dealer for service and/or spare parts.
3. General Guidelines
d abuse. Avoid brute force when operating the device.
s of the device before actually using it.
dden for safety reasons. Damage caused by user modifications to the
device is not covered by the warranty.
use the device for its intended purpose. Using the device in an unauthorised way will void the warranty.
uidelines in this manual is not covered by the warranty and the dealer
will not accept responsibility for any ensuing defects or problems.
4. Operation
Refer to the illustrations on page 2 of this manual.
Installation
1. Mount the LED strip in the desired location. The LED strip can be cut every 10 cm (see [A]). The cut ends must
be protected to avoid shortcircuits.
2. Connect the LED strip to the controller (connecting tools not included). Make sure to connect matching wire
colours. Do not shortcircuit any wires.
3. Connect the included power adaptor to the controller. Plug the other end into the mains.
153.758
RGB only use
1. Aim the remote control towards the IR LED of the controller to control the output of the LED strip.
2. Switch the LED strip on with the ON button on the remote control. To switch it off again, press the OFF button.
3. Select the desired light output colour by pressing the corresponding colour button on the remote control.
4. To increase or decrease output brightness, press the or button (8 gradations).
5. Press the effect buttons to generate different effects:
Effect button
FLASH 7 colours switching
STROBE gradual change
FADE 7 colours gradually changing
SMOOTH red, green, blue colours switching
5. Battery
Refer to illustration on page 2 of this manual.
The remote control uses 1 battery type 3 V lithium CR2025 (included).
1. To (re)place the battery, press on the side of the battery cover and pull to slide it open.
2. Insert the battery with the correct polarity and close the battery compartment by pushing it back into the housing
of the remote control until it snaps into place.