Assembly Procedure - DAYCO KWD1001 Montage

DAYCO AFTERMARKET
TECHNICAL INFORMATION
• Loosen the hub nut by no more than 90°.
• Raise the vehicle on the lift positioning it perfectly horizontal.
• Remove the wheel.
• Remove the brake caliper without disconnecting the pipes.
• Remove the brake caliper support.
• CAUTION: tie the brake caliper so that it does not overhang from the brake oil pipe only.
•
Remove the wheel rpm sensor.
•
Remove the brake disc.
•
Undo the nuts shown. (Fig. 1)
•
Remove the lower arm from the stub axle.
•
Undo the hub nut.
"RESPECT THE INSTRUCTIONS OF THE VEHICLE'S MANUFACTURER"
This document is the exclusive property of the single-member company Dayco Europe S.r.l. All publishing, use and reproduction rights of this document are reserved exclusively to the single-member company Dayco Europe S.r.l.

ASSEMBLY PROCEDURE

Fig. 1
Fig. 2
www.dayco.com