Télécharger Imprimer la page

WATTECO Modbus Class A Guide De Démarrage Rapide page 4

Publicité

Connectiques
Connectors
Utiliser un câble souple avec une gaine avec un Ø compris entre 2.5mm à 6.5mm et des fils
monobrin (ou multibrins avec embouti serti) 20-26AWG.
Use a flexible cable with a sheath with a diameter between 2.5mm and 6.5mm and single-
stranded (or multi-stranded with crimp) 20-26AWG wires.
Embase
Base
Ecrou
2
Nut
Maintenir l'embase(1) du presse-étoupe et desserrer légèrement l'écrou(2).
Hold the base(1) of the cable gland and slightly loosen the nut(2).
Enfiler le câble en faisant attention à ne pas blesser le joint(3).
Thread the cable, taking care not to damage the seal(3).
Dégainer le câble sur environ 10cm. Ajuster le câble puis resserrer l'écrou.
Strip the cable for about 10cm. Adjust the cable and retighten the nut.
1
Joint d'étanchéité
3
Gasketing

Publicité

loading

Ce manuel est également adapté pour:

Modbus class b50-70-08050-70-109