hudson valley KBS1428102 Guide D'installation

OUTLET BOX
SET SCREW
METAL SHADE
LAMP
BALL NUT
Thank you for purchasing our lighting fixture.
Please clean with a soft, dry cloth ONLY! Do
not use cleansers.
www.hudsonvalleylighting.com/mitzi
GENERAL
1. To ensure the success of the fixture installation, the following instructions and diagram(s)
should be read and understood.
2. All electrical connections must be made in accordance with the National Electric code and
local codes and ordinances. If you are uncertain of the methods of installing electrical wiring
and lighting fixtures secure the services of a qualified licensed electrician.
TOOLS NEEDED
Blade screwdriver, phillips screwdriver, slip joint pliers or small adjustable wrench, wire
cutter/stripper, electrical current tester, stepladder, and electrical tape.
INSTALLATION PREPARATION
1. TURN OFF THE ENTIRE ELECTRICAL CIRCUIT TO WHICH THE
LIGHTING FIXTURE IS TO BE ATTACHED. Turn circuit breaker to the "off" position
or completely remove the fuse controlling the circuit.
2. If an existing fixture is being replaced, remove it, and note to which of the wires in the
MOUNTING SCREW
outlet box the fixture was attached. DO NOT SEPARATE MULTIPLE TWISTED
GROUNDING SCREW
WIRES THAT MAY BE IN THE BOX. DO NOT DAMAGE THE INSULATION
OF OLDER WIRING. In regular circumstances the BLACK wire will be the "Hot" lead and
the WHITE wire will be the "Neutral" or "Common" lead. A GREEN or BARE COPPER wire
is the "Ground". In older buildings it is always good practice to reconfirm the polarity of the
wiring.
3. This fixture is designed to be mounted on an octagon box. The box must be securely
mounted to the structure of the building.
FIXTURE INSTALLATION
1.Remove the fixture and parts bag(s) from the carton. Before discarding the carton, double
check package to make certain that all parts are found.
2. Attach the mounting plate onto the outlet box by using the (2) mounting screws.
3. Loosen the set screw and remove the front metal shade.
4. Fasten the bare ground wire to the green or bare copper wire in the outlet box or the green
screw on the mounting plate.
NEVER FASTEN THE GROUND WIRE TO THE BLACK OR "HOT" WIRE !
FAILURE TO FOLLOW THIS INSTRUCTION COULD RESULT IN SERIOUS
INJURY OR DEATH !
5. Fasten the white wire from the fixture to the white wire from the outlet box.
Fasten the wires together with an approved fastener (wire nut) Starting about 1" below the
fastener, tightly wrap the connection with electrical tape so that the tape seals the end of the
fastener. Make sure that there is no exposed wire or strands that could cause a
dangerous short circuit !
6. Connect the black fixture wires to the black wire in the outlet box. Fasten the joined wires as
in step 5.
7. Place the back plate over the outlet box and fasten it by ball nuts.
8. Install the lamp(s). The fixture is rated for 4-watt type G9 LED lamps.
DO NOT EXCEED RECOMMENDED WATTAGE !
9. Restore the front metal shade by the set screw.
10. Restore power to circuit at breaker or fuse box.
DIMMING
The fixture can be controlled by a wall dimming device. Only use Triac/electronic dimmer. Make
sure the carton is marked for use with LED compact fluorescent-incandescent light source only.
These can be provided by your local electrical distributor, home center, or hardware store.
KBS1428102