Voltage Measurement - BEHA UNITEST Hexagon 50 Mode D'emploi

5.0 Commissioning
General Information to carry out measurements
Measurements in dangerous proximity of electrical systems are
only to be carried out in compliance with the instructions of a res-
ponsible electronics technician, and never alone.
Test leads and test probes may only be touched at handle surfaces
provided. Absolutely avoid the direct contact of the test probes.
Prior to switching to a new measurement range or a new type of
measurement, remove all connections from UUT.
Measurements have to be carried out by respecting the standards.
5.1

Voltage Measurement

To avoid electrical shock, the valid safety measures and VDE direc-
tives strictly have to be met concerning excessive contact voltage
when working with voltages exceeding 120V (60V) DC or 50V
(25V)rms AC. The values in brackets are valid for limited areas
(such as e.g. medicine, agriculture).
32