Dhb-100 - ELTRACE DomoClick DHB-100 Manuel D'installation

DOMOCLICK
C
ONNECTION SET WITH ELECTRICAL SUPPLY
Connection set with electrical supply for the junction between the ELTRACE heating cable and the supply cable.
Box and cover in polyamid, Domoclick Heating Cable Connector, Ligature, Incorporated electrical connection inclu-
ding cablegland PG 16, Stirrups for wall mounting, CE
C
OMPOSITION
Incorporated electric supply boxDomoclick Heating Ca-
ble Connector
1 terminal
2 heat-resistant ligatures
2 stirrups for wall mounting
Self-adhesive labels "electric supply" and "terminal"
E
ASY
Eltrace heating tapes are supplied and connected between themselves with a minimum of manipulations. Only a knife
in needed to strip the band ends. The different clicks are made up of only three parts.
S
URE
The mounting stages are visible and easily controllable. The upper and lower blades guarantee a sure contact.
F
AST
It takes only a few minutes to assemble the Click, for it involves only four stages:
1. Insert the band into the cover and the metal cone
2. Strip the band end.
3. Insert the heating tape into the Click.
4. Push the lever and shut the cover.
I
NSTALLATION PRESCRIPTIONS
The installation of bands, connections to DomoClick
the rules of the trade.
Before going ahead with work on electric tracers, care will be taken to isolate them from the mains.
The DomoClick® connection and junction techniques are approved if used together with self-adjusting Eltrace heating
tapes. Eltrace guarantees correct working only in relation with the mentions heating tapes.
Through the direct mounting onto the pipe, DomoClick
As a general rule, DomoClick
wall with supplied stirrups.
The supply cable is to bedirectly connected into the DomoClick
thus avoided.
In anti-frost installations for gutters, DomoClick® must not be installed in a gutter or on the roof, but in a sheltered
position under the roof or eave.
®
DomoClick
are admitted. Important : for admitted temperatures of heating tapes, refer to the technical data
®
DomoClick
ble. Electrical supply points and terminals must be indicated with the supplied self-adhesive labels.
Q
UALIFICATIONS
Certifications CE
ELTRACE - 12, rue des frères Lumière - F-77290 - MITRY MORY - France - Tel: +33 (0)1 64 62 04 40 - Fax: +33 (0) 1 64 62 00 54 - www.eltrace.com - info@eltrace.com
In order to improve the quality of our products ELTRACE reserve the right to make changes—20140617 Domoclick Fast Connector
®
F C
AST ONNECTOR
DOMOCLICK DOMOCLICK
DOMOCLICK
®
is fixed to the pipe with the supplied ligatures. DomoClick® can also be fixed to the
can be installed directly on pipes with a service temperature of less than 70°C. Short periods at 80°C
incorporated into pipe insulation. All supply points, junctions and terminals must remain accessi-
P
RODUITS
®
® ®
- - DHB- DHB - 100 100
- DHB - 100
®
connectors to connection boxes will be carried out according to
®
uses less heating tape.
®
. Any exterior supply, junction or derivation box is