LEGION LIGHTING 4323 Serie Manuel D'installation

Installation Instruction
WARNING
•
To reduce the risk of death, personal injury or property damage from fire, electric shock, falling
parts, cuts/abrasions, and other hazards read all warnings and instructions included
with and on the fixture box and all fixture labels.
•
Before installing, servicing, or performing routine maintenance upon this equipment, follow these
general precautions.
•
Commercial installation, service and maintenance of luminaires should be performed
by a qualified licensed electrician.
•
For the installation: If you are unsure about the installation or maintenance of
the luminaires, consult a qualified licensed electrician and check your local
electrical code.
•
To prevent wiring damage or abrasion, do not expose wiring to edges of sheet metal
or other sharp objects.
•
Do not make or alter any open holes in an enclosure of wiring or electrical components during kit
installation.
WARNING
•
Turn off electrical power at fuse or circuit breaker box before wiring fixture to the power supply.
•
Turn off the power when you perform any maintenance.
•
Verify that supply voltage is correct by comparing it with the luminaire label information.
•
All wiring connections should be capped with UL approved wire connectors.
CAUTION
•
Avoid direct eye exposure to the light source while it is on.
•
Account for small parts and destroy packing material, as these may be hazardous to
children.
•
Risk of burn. Disconnect power and allow fixture to cool before changing bulb or handing fixture.
Green ground screw provided in proper location.Do not relocate.
NOTICE:
Minimum 90° supply conductors.
NOTICE:
General Wiring Diagram
Black(Line)
White(Neutral)
120-277v
Green(Gnd)
Dimming wire
to 0-10v IEC
compliant control
Legion Lighting Co., Inc. | 221 Glenmore Avenue, Brooklyn, NY 11207 | Phone: 718-498-1770 | Fax: 718-498-0128 | Toll Free: 1-800-4-LEGION | email: sales@legionlighting.com |
Wrap Light Economy
Lead wire to
LED load
Installation Step:
1. Remove the end cap screws and remove the endcap
2. Slide out the diffuser
3. Remove the LED heat sink
4. Disconnect quick connector
5. Attach junction box rounded covers to the luminaire
6. Make wire connections as shown on the electrical diagram
7. Anchor the luminaire to the ceiling surface
8. Assemble in reversed order and turn on power
Series 4323
www.legionlighting.com