General Installation - monte carlo MC266 Serie Instructions D'installation

1
Before you begin installing the fan, Switch
power off at Service panel and lock
service disconnecting means to prevent
power from being switched on
accidentally. When the service
disconnecting means cannot be locked,
securely fasten a warning device, such
as a tag, to the service panel.
4
Hex nut
Lock washer
Light fixture
Remove the hex nut and lock washer from
the light fixture. Keep parts.
7
Show different type
of wiring
Connect white wire from light fixture
with white wire from fan and then
connect black (or blue) wire from light
fixture with blue (or black) wire from
fan.
© 2021 Monte Carlo Fan Collections

GENERAL INSTALLATION

2
Switch
housing
Remove set screws from switch housing.
Keep screws.
Switch housing may be different than
shown.
5
Switch housing
Tap
Remove tap from bottom of switch housing.
Thread lead wires from light fixture through
central hole in switch housing and then
install switch housing onto light fixture by
turning clockwise till tight.
8
If wiring with plugs, connect the plug
from fan to the plug from light kit
assembly. Make sure the plugs are
clasped firmly.
Install light kit assembly (switch
housing) onto the fan with the set
screws removed in step 2.
Note
: There may be a light switch on
switch housing of some fans. Make
sure it is turned on.
3
3
Switch housing, plugs may be
different than shown
Unplug (If wiring with quick connectors)
and remove the switch housing from fan.
6
Hex nut
Lock washer
Pull chain guide
Place the lock washer and hex nut over the
lead wires from light fixture and tighten
securely with the thread rod of light fixture.
Feed pull chain into the hole in pull chin
guide.
9
Install 2 x 9-watt medium base enclosed
type of LED lamps.
Caution: Approved for use with LED light
bulb only (Part No. 97512S).
Do not use incandescent light bulb.
Caution: Do not replace bulb until it cools
down.
Bulb
12/2021