Use Of The Device; Cleaning And Maintenance - Livoo DOH135 Notice D'utilisation

6 Cliff sensor
7 Main wheel
Round brush
8

Use of the device

Remove any debris or bulky object from the floor before using the appliance.
The unit can be used on any type of floor.
Insert the two side brushes (see Figure 3). Press down until they are secure. To remove them, simply pull
them up (see Figure 7).
Place the self-adhesive velcro tape on the underside of the device (see Figure 5). Place the supplied
wipe (previously moistened) on the velcro tape (see Figure 5).
Charging operation
Insert the micro USB port of the cable into the micro USB port on the unit (see Figure 2).
Insert the USB port of the cable into the AC adapter.
Plug the AC adapter into a wall socket.
The green indicator light will illuminate indicating charging.
Operation of the indicator light :
The indicator light is steady, the appliance is on.
The indicator light goes out, the device is switched off.
The indicator light on the button flashes twice in a row with an interval of 2s, the battery is low.
The indicator light on the button flashes three times in a row with an interval of 2 seconds, the suction is
blocked.
The button indicator flashes four times in a row with an interval of 2s, one of the brushes is blocked.
The button indicator flashes rapidly for 1s, the unit is not charging.
Operation of the device
Press the on/off button (Figure 4) for a few seconds, the indicator light comes on and the vacuum
cleaner starts. The vacuum cleaner will start to vacuum according to its trajectory.
Press briefly to interrupt the vacuuming and pause the vacuum cleaner.
Press again briefly to restart the appliance. The appliance will automatically switch off after 5 minutes if
it is not restarted.
Press the on/off button for a few seconds, the indicator light goes out and the appliance switches off

Cleaning and maintenance

Before cleaning the appliance, make sure it is switched off.
Cleaning the suction inlet and side brushes
Clean the suction inlet with a soft, moistened cloth (Figure 6).
Remove the side brushes and clean them manually (Figure 7).
Cleaning the dust container and filter (Figure 10)
Open the hoover lid and remove the dust container,
Open the tank lid and remove the filter. Empty the tank, run it under water and dry it.
Tap the filter to remove dust. Replace the filter, cover and tank.
Replace the vacuum cleaner cover.
Make sure the bottom edge of the cover is aligned with the base before pressing it down firmly.
www.livoo.fr
.