Publicité
Les langues disponibles
Les langues disponibles
The retrofitting set consists of:
Control unit HDS 160
4 screws
Adapter cable 2-pin (power supply)
Adapter cable 8-pin (control cable)
Coaxial connection cable with F-connectors
Operating instructions for HDP 170
Additionally required:
Digital satellite receiver UFD 540, order no. 260515
The mounting set UFZ 540, order no. 20410006, is used
for secure installation of the receiver UFD 540 in a caravan
or mobile home.
Important instructions:
For adaptation to digital reception, a planar
antenna BAS 60 must be mounted on the
!
automatic positioner HDP 160. Good reception
is not possible with the older planar antenna
BAS 50.
Gefahr
Attention
However, you have the possibility to retrofit an older HDP
150/BAS 50 system to digital reception. For this, the planar
antenna BAS 60 and the following parts are required:
-1 sheet
order no. 039 4841
-1 sleeve
order no. 010 3742
-2 plates
order no. 926 129
-2 screws M3
order no. 048 870
An adaptation of the planar antenna BAS 60 on the
automatic positioner HDP 150 is only possible and
permissible with the use of these components. Ensure, that
there is adequate space of Ø 96 cm around the rotating axle
of the positioner for the BAS 60! Danger of collision!
You can order the parts from:
ESC Elektronik Service Chiemgau GmbH
Bahnhofstraße 108, 83224 Grassau, Germany
The adaptation work may only be carried out by qualified specialist personnel!
It is advisable to dismount the planar antenna BAS 50 with the older control unit. By pressing the
!
"SUCHEN" button, the antenna support is raised, and the antenna BAS 50 can be dismounted and
replaced with the planar antenna BAS 60.
Lower the antenna support again to the "parking" position.
Gefahr
Attention
Then, exchange the control unit and receiver.
When working on the mains supply, the power supply must be disconnected, in order to avoid
short-circuits.
When working on the rotating unit, the power supply must be disconnected.
Attention! Danger of being pinched by the moving parts.
Reconstruction instructions
– The control unit HDS 160 functions only in conjunction with the Kathrein
digital receiver UFD 540.
– Retrofitted systems with the control unit HDS 160 cannot be operated with
an analogue receiver.
It is not possible to operate the unit with receivers from other manufacturers.
– The older control unit of the HDP 160 or CAP 100 does not function with the
digital receiver UFD 540!
Instructions for retrofitting
the automatic positioner HDP 160
to digital reception
The control unit has an exchangeable 10 A flat fuse
After a fuse has blown, the source of failure must be
found and removed.
The defective fuse may only be exchanged with a
fuse with the same nominal value (10 A)!
Control unit HDS 160
Fig. 1
near the plug-in connections.
Electronic equipment is not household
waste – in accordance with directive
2002/96/EC OF THE EUROPEAN
PARLIAMENT AND THE COUNCIL of
27th January 2003 on used electrical
and electronic equipment, it must be
disposed of properly.
At the end of its service life, take this
unit for disposal at a relevant official
collection point.
Publicité
