Loading Instructions - Uline H-1132 Mode D'emploi

1. Open dispenser
cover.
2. Push in the slide
until the dispensing
opening is exposed.
(See Figure 3)
3. Select appropriate dispensing opening on insert and
rotate into position until it locks into place. Release
the slide so it fully opens. (See Figure 4)
Figure 4
Insert
#4
#2
ITEM #
S-7724
S-15752
S-7725
S-11827
S-12851
4. Remove perforated cardboard core from center of
towel roll, if applicable.
NOTE: Dispenser comes with turn knob installed,
not keyed lock. If keyed lock is desired, see
instructions below.
KEYED DOOR OPERATION
1. Open dispenser to reveal latch mechanism on side
of cover. Release latch button by removing pin in
latch button stem. Pull latch button out and save for
future use. (See Figure 7)
2. Insert key and turn.
PAGE 2 OF 6

LOADING INSTRUCTIONS

Figure 3
Slide
Dispensing Opening
#3
#1
BRAND SETTING
Uline #3
Uline #3
Scott #1
Scott #1
Kleenex #3
KEY INSTRUCTIONS
5. Start roll from center
by pulling out
approximately
6" of leading edge.
6. Load roll by feeding
leading edge
downward into
opening. Ensure roll
is seated completely
in recess of dispenser.
(See Figure 5)
7. Close the cover firmly while making sure the towel
doesn't get caught inside.
NOTE: If cover is not locking, twist key
counterclockwise to close latch mechanism.
8. Begin dispensing. Tear off the first few crumpled
sheets. (See Figure 6)
NOTE: To clean
dispenser, use
a soft wipe with
mild soap
and water.
Figure 7
1-800-295-5510
uline.com
Figure 5
Dispensing
Opening
Recess
Figure 6
Latch Button
Pin
0123 IH-1132