Horizon Global 76384 Instructions D'installation page 3

Always wear SAFETY GLASSES
when installing hitch
Access
hole
Conical
Washer
Teeth side
Against hitch
Fasteners
typical on
both sides
1. Drill hole – Using a 2.5" hole saw drill through rear bumper cover at predefined dimple located in center of cover, see Figure 1. Insert (1) 3/4" flat
washer ①, (1) 3/4" lockwasher ② and (1) 3/4" bolt ③ through the hole.
2. Feed (2) 1/2" carriage bolts ⑤ and (2) spacers ⑥ through access holes on both end of bumper beam cross member using the pull wires ⑨, see
Figure-2 & 3. Leave pull wires attached.
3. Install Hitch – Raise hitch into position. Loosely install 3/4" bolt ③, (2) 1/2" conical washers ⑦, and (2) 1/2" hex nuts ⑧ to the hitch.
4. Tighten all 1/2-13X1.50 GR5 fasteners to 75 ft-lb (102 N*m) and 3/4-10X2 GR 8
5. Install Bolt Cap - Apply silicone sealant to head of 3/4" bolt ③ and install (1) bolt cap ④ on head of the bolt.
fastener to 250 ft-lb (339 N*m).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and
exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut
access or attachment holes with a torch. This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.
Regulation V-5 and SAE J684.
©2021 Horizon Global Americas Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 76384, 84384, CQT76384
4
3
2
A. Insert bolt and
1 Block into frame
5
6
7
8
Figure 3
B. Align block on C. Pull bolt
access hole thru block
Figure 2
Access
hole
Sheet 3 of 15
Fastener Kit: 76384F
① QTY. (1) WASHER, FLAT 3/4"
② QTY. (1) LOCKWASHER 3/4" PLATED
③ QTY. (1) BOLT, HXHD 3/4" -10X2 GR 8
④ QTY. (1) CAP BOLT (BLACK RUBBER)
⑤ QTY. (2) BOLT, CARR 1/2"-13X1.50
⑥ QTY. (2) BLOCK .250X1.00X3.00
⑦ QTY. (2) WASHER CONICAL 1/2"
⑧ QTY. (2) NUT HEX 1/2"-13 GR 5
⑨ QTY. (2) WIRE, PULL (1/2" - 13)
Figure 1
76384NP 02-24-21 Rev. B