Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Color profile: Disabled
Composite
Default screen
Charging the Battery Pack
The rechargeable Nickel-Cadmium battery pack must be fully
charged before using your phone for the first time. Before
plugging the phone line into your new phone, you must
charge the battery for approximately 15-20 hours
without interruption.
1. Remove the handset battery cover. (For initial charging, the
battery pack will already be inside the compartment, but
will not be plugged in.)
2. Plug the battery's cable
into the handset.
The plastic connectors will fit together only one
way. Make sure the battery's connector is
properly aligned. Use only the battery pack
NOTE
(model BT-905) supplied with your phone.
3. Replace the battery cover.
Charging the Handset
Place the handset on the
base to charge. (The
handset can charge in
either the face-up or
face-down position.)
H:...MPH 6955 Map OM.vp
Mon Jun 28 16:00:12 1999
All manuals and user guides at all-guides.com
Installation
5
Low Battery Indicator
When the battery pack in the handset
is low and needs to be charged, the
BATT LOW LED flashes every 3 seconds.
If this occurs while you are on the
phone, you will hear an alert tone.
Complete your call as quickly as
possible, and return the handset to
the base for charging.
Cleaning the Battery Contacts
To maintain a good
charge, it is important
to clean all battery
contacts on the handset
and base about once a
month. Use a pencil eraser
or other contact cleaner.
Do not use any liquids
or solvents.
Selecting a Location
Before choosing a location for your new phone, read the
"Installation Considerations" included in the "Precautions and
Important Safety Instructions" brochure.
Important: Do not place the power cord in an
area where it may create a trip hazard or
become chafed and create a fire or
electrical hazard.
Setting the Dial Mode Switch
Place the switch in the
T position for tone dialing, or
the P position for
pulse dialing.
Publicité
Table des Matières
