Numark WS100 Guide D'utilisation page 4

Receiver
Front Panel
6
1. Power Button: Press this button to turn the receiver on or off.
2. Power Indicator: When lit, this LED indicates the receiver is powered on.
3. RF Indicator: When lit, this LED indicates that the receiver is receiving a signal from the
transmitter.
4. AF Indicator: When lit, this LED indicates the current audio signal level received from the
transmitter.
5. Volume Knob: Turn this knob to adjust the volume level of the Mic Output and Line
Output.
6. Antennae: These antennae receive the signal from the transmitter. Place the antennae in
a vertical position for the best signal quality.
Rear Panel
1. Power Input: Use the included power adapter to connect this input to a power outlet.
2. Mic Output (1/4" / 6.35 mm): Use a standard 1/4" (6.35 mm) cable to connect this
balanced output to your mixer, PA system, etc. Make sure the input of the connected
device is set to receive a mic-level audio signal.
3. Line Output (1/4" / 6.35 mm): Use a standard 1/4" (6.35 mm) cable to connect this
unbalanced output to your guitar amplifier, mixer, PA system, etc. Make sure the input of
the connected device is set to receive a line-level audio signal.
4
3
5
4
1
2
2
3
1
6