Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
control block. Higher or lower flames will become visible.
The temperature is controlled by the height of the flame,
which is activated by the motor on the gas control block.
The flame height will depend on such things as the size of
the room and the heating capacity of the appliance.
Programming the timer
Programme the heating time by pressing TIMER until P1
starts to flash. Now set the time that the heater is to
come on, by pressing ( ) for the hours and ( ) for the
minutes. Press TIMER again until
P1
starts to flash. Now set the time you want the
heater to switch off. Press TIMER again to programme a
second period (P2
and P2
return to "timer" mode.
In "timer" mode
will appear in the display if the actual
time is not within the programmed heating period. If this
appears in the display (heating period off), then only the
pilot light will burn.
Adjusting the flame height in manual modes
Instead of the programmed temperature control, you can
also switch to "manual" mode by pressing either the ( )
or ( ) button. Pressing the ( ) button will increase the
flame and pressing ( ) will decrease the flame. This will
turn switch B (fig. 2) on the gas control block.The "send"
symbol is now visible in the top left corner of the display.
Manually operating button B will have the same result. A
little effort is needed to turn switch B, and a clicking sound
is perfectly normal.
If you want to return to "timer" or "automatic" mode,
press TIMER or AUTO briefly.
If you go to "automatic" mode, the programmed
temperature will appear briefly in the display, followed by
the current room temperature.
If you are in "timer" mode, you can view the programmed
temperature by pressing AUTO. Press TIMER again to
return to "timer" mode.
Replacing the battery
If BAT appears in the top right-hand corner of the display,
the battery needs replacing.
NB: Before the AUTO or TIMER mode can be used, check
that the remote control ("send" symbol should appear in
the display) and the receiver (LED lights up) are both
working properly.
Important
A built-in safety lock is activated when the appliance is
switched to "OFF" (closed down setting).Therefore, wait 5
minutes before relighting the heater.Within this period, do
not try to push the lighting button, as this has been
blocked by the safety lock. Do not force the button, as this
may result in damage to the mechanism.
).Wait or press TIMER to
Inserting or replacing the batteries
In the receiver
• Open the door at the front.
• Take the receiver and open the cover.
The batteries are under that cover.
• Remove the old batteries and insert the new ones,
making sure that the + and – signs on the batteries
correspond with those in the holder.
In the remote control
• Remove the cover on the back of the remote control.
• Connect a square battery (type 6LR61) to the clip.
• Fit the battery in the holder.
• Replace the cover.
NB: Do not throw old batteries in the dustbin.They
should be treated as Chemical Waste.
11
fig. 3
Publicité
Table des Matières
