RAB UC-120 Instructions D'installation

UC-120 LED WIRING COMPARTMENT
INSTALLATION INSTRUCTIONS
ELECTRICAL SHOCK HAZARD
WARNING
Disconnect the Electrical supply power at the service panel (fuse or circuit breaker box). Failure to do so could result in serious
injury or death. Only qualified electricians should install this fixture and the installation MUST conform to the Canadian
Electrical Code Part I and all local codes and ordinances. Ensure that only proper tools, materials, and equipment are used to
complete the installation.
SAFETY

Proper grounding is required to ensure personal safety.

Fixture should be mounted in locations where unauthorized personnel will not readily subject it to tampering.

Do not use this equipment for anything other than its intended purpose.

Servicing this equipment should be performed by qualified service personnel.

Save these instructions.
INSTALLATION
1. Remove the top cap from the compartment box by loosening top screws.
2. Mount the compartment box to the desired location.
3. Reattach the top cap to the box by tightening the screws.
4. Connect the Black Flex cable to a junction box (not included), as per the
wiring instructions.
5. Connect the white two prong cable to UC-120 LED.
WIRING

Check that the line voltage is correct.

Connect fixture GROUND (green) wire to power supply GROUND (green) wire.

Connect fixture WHITE wire to power supply NEUTRAL wire.

Connect fixture BLACK wire to power supply LINE wire
RAB Design Lighting inc.
READ, UNDERSTAND
before installing the equipment.
Junction Box
2019-04-29
FOLLOW
, and these instructions
Compartment Box
White two
prong cable
UC-120 LED
Page 1 of 1