Publicité
Liens rapides
Publicité
Manuels Connexes pour Kuat PIVOT v2
Sommaire des Matières pour Kuat PIVOT v2
- Page 1 PIVOT v2 ™ PASSENGER-SIDE DRIVER-SIDE USER GUIDE...
- Page 2 Toggle Clamp Hitch Pin Post Toggle Clamp (4) M8 Lock Washer (4) M8 x 12 (2) Lock Keys Bolt These instructions depict the Pivot v2 swing. Passenger Side ™ Assembly and installation steps for the Driver Side are identical. Assembly...
- Page 3 Using the 5mm hex key, attach the toggle clamp with (4) M8 x 12 bolts and (4) M8 lock washers. Tighten bolts to 16 ft/lbs (22Nm). Secure the toggle clamp. Using a 13mm wrench tighten “A” bolts until snug. Lever should require some force to close. It will break-in and require retensioning from time to time.
-
Page 4: Rack Installation
Installing Pivot v2 into Hitch ™ Slide Pivot v2 into hitch and align the hitch pin holes. ™ Insert hitch pin and secure with hitch lock. Fully tighten FlatLock hitch cam using the provided 8mm hex key. Do not exceed 25 ft/lbs (34Nm). - Page 5 Driving Before driving, ensure Pivot v2 swing arm is fully closed, ™ toggle clamp is secured to clamp post and in the closed position. Swing-Away Operation Push down on the toggle clamp to release swing-arm from toggle clamp post. Pull safety lever to release and articulate swing-arm.
- Page 6 WARNINGS • Do not tow with this product. • Confirm the product you intend to use in the Pivot v2 is approved by the manufacturer. ™ • You are responsible for confirming you do not exceed your vehicle’s tongue hitch weight.
-
Page 7: Limite De Responsabilités
Küat Innovations LLC. Limited Lifetime Warranty Küat honors the warranty on all Küat brand products for original owners of the product. Warranty is not transferable. If a Küat rack that is covered by the terms of this warranty and is determined by Küat, to be defective, Küat will repair or replace the defective parts. - Page 8 1.877.822.5828 info@kuat.com kuat.com info@kuatracks.com 1.877.822.5828 v.09...