LUXART Mainline Vitreous China Instructions De Montage

Rectangle Vessel Lavatory
Rectangulaire sur comptoir
Installation Instructions/ Instructions de montage
Recommended Tools and Materials:
Putty Knife
Plumbers' Putty
Pipe Wrench
Adjustable Wrench
Channel Lock Pliers Tubing Cutter
1
Using the template provided, locate the position of the sink
on the countertop. Provide proper clearance under the
countertop for the faucet supply lines, drain assembly and
the structural parts of the cabinet.
NOTE: If replacing an existing sink be certain to shut off
water supply before removing old sink.
2
Drill a clearance hole inside the perimeter line of the
template for countertop installation.
Perimeter
of
template
Cut opening around the perimeter of the template.
3
Mount the faucet and drain
assembly (not included) on
the sink following the
manufacturer's instructions.
Be certain to apply a bead
of sealing putty on the
underside of the drain (Part
"A") in order to ensure a
watertight seal between the
sink and drain. Remove
excess putty after installing
drain on sink.
Tape Measure
Silicone Adhesive
Basin Wrench Regular Screwdriver
Phillips Screwdriver
Perimeter of
template
A
VITREOUS CHINA
Drill
Saber Saw
Hacksaw
4
• Place the sink temporarily into the template.
• Check for alignment and clearance.
• Mark the sink and countertop in several places
as a guide for the installation location.
5
After checking fit
and alignment,
turn sink upside
down and apply a
generous portion
of silicone
adhesive around
the under side of
the rim near the
edge. Place sink in
position. Wipe off
excess adhesive.
6
Mounting holes are provided on the rear of the
lavatory so it can be secured to the wall if desired.