Note: DO NOT tighten any bolts until all bolts have been started; Philips screw driver NOT included.
1.
Attach the left side (D), right side (E), and back
(F) with 4 bolts ¼ in x 15 mm (M), 4 flat washers
(N) and 4 spring washers (P) by using the Allen
wrench (J) as shown on the right,(see Figure1).
2. Attach the gas cylinder holder (H) to the left side (D) and right side (E) with
(M), 4 flat washers (N) and 4 spring washers (P) by using the Allen wrench (J), (see Figure 2).
INSTALLATION
Figure 1
4 bolts ¼ in x 15 mm
Figure 2
Page 9 of 46