Hudson Pro 23001 Instructions

Connect with us!
DANGER: TO PREVENT SERIOUS INJURY OR DEATH: Do not operate Inflator/Deflator while car engine is running in an enclosed area.
PRODUCT SPECIFICATIONS
OPERATION
CAUTION: TO PREVENT OVERHEATING WHILE INFLATING, keep the air intake and vents clear of obstructions. Always
wear appropriate eye protection during use.
WARNING: TO PREVENT SERIOUS INJURY FROM EXPLOSIONS: Before inflating, check item manufacturer's
recommended max air pressure. DO NOT exceed that pressure. Over inflation may result in an explosion.
Note: The inflator/deflator has a sleep mode feature that powers off the unit after approximately 5 minutes of non-use.
Press the power button to turn the unit back on.
Notice: The inflator/deflator can become hot during use. Allow the unit to cool for ten minutes after each use.
Inflator/deflator needs to cool 30 minutes before storing away.
TIRE INFLATION
1. Remove the high-pressure hose from its
storage area.
2. Remove tire's valve
cap. Move tire inflator's
lever to the up position,
insert tire adapter if
needed, then move the
lever down to lock in
place.
3. Plug unit into the
vehicle power outlet.
4. Turn unit on by turning
the power switch on high
(||)
5. Once desired pressure
is reached, simply move
the tire inflator lever up
to unlock and remove.
6. Turn the unit off by moving the switch
to the center (O)
Note: Please refer to your vehicle or bicycle
manual for appropriate pressure.
1-800-9-SPRAYER
ladybug@hdhudson.com
Instructions for 12V Vehicle Power Outlet Inflator/Deflator
Customer service is here to help! If you have any questions or concerns, do not return to the store.
WARNING: TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Power Switch is in the off position before performing any procedure.
Model:
Maximum pressure
Power source
Automatic shut off
Low pressure hose length
High pressure tire inflator hose length
Cigar-lighter cord length
Accessories
1. Remove the high-pressure hose
from its storage area
2. Plug unit in with preferred power
source.
3. Turn unit on by turning the power
switch on high (||)
4. Once desired pressure is reached,
simply move the tire inflator lever up to
unlock and remove.
5. Turn the unit off by moving the
switch to the center (O)
Call 1-800-9-SPRAYER or email ladybug@hdhudson.com
23001 or 23002
160 PSI/ 11Bar/ 1100kPa
12V Cigar-Lighter
Yes
14 inches
32 inches
125 inches
• Tire adapter x1 • Ball adapter x1 • Raft/Mattress adapter x1
BALL INFLATION
230020 Instructions 23001-23002
Instructions
RAFT/MATTRESS INFLATION
1. Remove the high-pressure hose
from its storage area.
2. For smaller inflatables: Move tire
inflator's lever to the up position,
insert raft/mattress adapter, then
move the lever down to lock in
place.
3. For larger inflatables: Remove
high-volume hose from storage,
connect it to the back of the unit
by aligning the slots in the hose
to the pins and turn the hose
counterclockwise to lock in place.
4. Insert the other end of the hose
into the inflatable.
5. Plug unit into the vehicle power
outlet.
6. Turn unit on by turning the
power switch on low (|).
7. Once desired air input is
reached, simply remove the hose
from the inflatable.
8. Turn the unit off by moving the
switch to the center (O).
©2019 Manufactured by H. D. Hudson
Manufacturing Company