Page 1
ASSEMBLY INSTRUCTIONS INSTRUCTIONS DE MONTAGE an LDI Company New Hope, MN 55428 INSTRUCCIONES DE ENSAMBLAJE www.safcoproducts.com 2196 Sit/Stand Keyboard/Mouse Arm Support de clavier/souris « assis/debout » Brazo para ratón/teclado “sentado/en pie” PRODUCT WARRANTY REGISTRATION is available online at: www.safcoproducts.com L’INSCRIPTION POUR LA GARANTIE DU PRODUIT est El REGISTRO PARA LA GARANTÍA DEL PRODUCTO está...
TOOLS REQUIRED: Phillips Screwdriver, Pencil, Drill with 1/8”bit, Masking Tape OUTILS REQUIS: Tournevis à pointe cruciforme Crayon, Perceuse avec mèche de 3 mm , Ruban de papier adhésif HERRAMIENTAS REQUERIDAS: Destornillador Phillips , Lápiz, Taladro con broca de 1/8 pulg., Cinta de ®...
Page 3
Safco Products Company, New Hope, MN 55428 2196-37MP: 3 of 7; Rev. 1; 11/09...
BACKSTOP HEURTOIR TOPE MASKING TAPE RUBAN DE PAPIER ADHÉSIF 90° CINTA ADHESIVA DE PINTOR 1/2” 12 mm Safco Products Company, New Hope, MN 55428 2196-37MP: 4 of 7; Rev. 1; 11/09...
Page 5
2196-37MP: 5 of 7; Safco Products Company, New Hope, MN 55428 Rev. 1; 11/09...
Page 6
Temporarily set the Keyboard Wrist Rest, your keyboard, the Mouse Wrist Rest, and the Clear Mousing Surface into place on the Keyboard Tray. Note that the Keyboard Wrist Rest has a slight slant, and the Mouse Wrist Rest has a slight curve; arrange these for your own comfort. Slide the two Keyboard Pads under the ends of your keyboard until they properly support it;...
Page 7
Adjust the Mechanism as follows: a) Lift the Keyboard Tray slightly to push in or pull out. b) Lift and press down or pull up to adjust the height; release to lock in place. c) Loosen the tilt knob on the right side of the Mechanism, position the Keyboard Tray at the desired angle, and retighten the knob.