Location Of Controls; Before Initial Use; The Kneading Machine - Herzberg HG-5029ORG Mode D'emploi

It is designed exclusively for this purpose and may only be
used therefor.
It may only be used in the manner described in this instruction
manual.
The appliance may not be used for commercial purposes.
Any other use is considered not as intended and may lead to
damage to property or even personal injury.
The manufacturer assumes no liability for damage resulting
from use other than the intended purpose.

Location of Controls

1 Worm drive cover
2 Swivel arm
3 Speed control knob
4 Lever for raising the arm
5 Motor housing
6 Mixing bowl
7a Kneading hook
7b Mixing hook
7c Egg beater
8 Protective disc
9 Drive shaft
10 Splash guard on mixing bowl
11 Tuile blender
12 Filler tray
13
14 Worm
15 Silicone coupling
16 Knife
17 Plate (3 different hole sizes)
18 Ring nut
Turn on/off
• Turn on: Select a speed setting between 1 and 10 on the
control panel.
• Turn off: Turn the knob to"0"
NOTE:
The motor has a safety switch. It switches the motor off as
soon as the arm (2) swivels up.

Before initial use

• Remove the appliance and all included accessories from
the box.
• In order to remove any production residue, clean all acces-
sories before initial use as described under "Cleaning".
Electrical Connection
tions on the type label.
5

The kneading machine

Assembly and operation
1. Push the lever (4) down. The arm (2) swivels up.
2.
Hold the splash guard with the collar facing up.
Push the splash guard into these recesses using the guide
grooves and lock into place by turning clockwise.
NOTE:
When preparing dough with the kneading or mixing hook,
you do not need the splash guard. This gives you the
option of adding ingredients whilst preparing the dough.
3. If you want to use the kneading hook
the protective disc (8). This prevents the rising dough from
coming into contact with the drive shaft.
Hold the disc like a bowl. Attach the kneading hook from
below through the disc recess and secure it with a quarter
turn.
4. On the top end of the attach-
ment, you will see a recess for
the drive shaft and the cotter.
Fit the required attachment by
inserting the top end into the
drive shaft (9). Push and turn
the attachment at the same time anti-clockwise, so that the
cotter locks into place in the drive shaft.
5. Place the mixing bowl into its holder and turn the bowl in
the LOCK direction as far as it will go.
6. Now add your ingredients.
CAUTION:
7. Push the arm down until it clicks into place.
8. Plug the mains plug into a properly installed 230 V ~ 50 Hz
Schuko socket. The operating status is indicated by the blue
LED indicator lamp.
9. Press a speed setting (button 1-10 ) on the control panel (3)
to turn the appliance on. The selected setting is indicated
by a blue LED.
-
-