Télécharger Imprimer la page

Telstar AQUAPRISM PRB12457 Notice D'installation Et De Maintenance page 2

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION AND MAINTENANCE GUIDE
BRONZE SPOTLIGHT
REFERENCES
Reference
Voltage
(V)
PRB12457
230
PRB12257
24
PRB180
-
PRB15157
12
I - INSTALLATION INSTRUCTIONS
®
Remove the screws
(1)
and the retainer ring
®
Pass the cable(s) into the spotlight through the cable glands (9).
®
Correctly insert the lower O-ring
(6)
®
Connect the wires to the socket
(8)
and connect the ground wire
®
Screw the bulb
(5)
into the socket
(8).*
®
Place the bulb
(5)
on the O-ring (6).
®
Insert the upper O-ring
(4)
in the retainer ring (3).
®
Put the retainer ring
(3)
on the bulb (5).
®
Tighten the 4 screws
(1)
so that the retainer ring
The retainer ring
(3)
must be in contact with the spotlight body (7).
®
The cable glands
(9)
should be torqued to a value between 1 and 2.5 Nm.
®
Install the spotlight on a fixed support by means of its base (10). The spotlight must be
completely immersed 5 to 10 cm below the water level.
®
Install the optional colour caps with screws (2). (Colour caps references CCJ150, CCB150,
CCV150 or CCR150).
®
In order to avoid over heating of electrical cables, the installer will minimize the lenght of
cable inside the light body.
EXPLODED VIEW
15*
16*
14*
9
11
10
* excepted for PR 15157.
For more information, refer to the technical information no. 03-005-07
Noncontractual document
TELSTAR COMMUNICATION
Power
Bulb Type
(W)
120
PAR38
120
PAR38
-
without bulb
100
PAR38
(3)
from the spotlight body (7).
in its groove.
(14).*
(3)
remains parallel to the body (7).
8*
12
13
Tel. : +33 (0)1 30 96 01 01 - Fax. : +33 (0)1 30 96 07 00 - info@aquaprism.com - www.aquaprism.com
Bulb
Reference
AMI12230
AMI12024
-
-
II - ELECTRIC INSTALLATION RECOMMENDATIONS
The electric lighting circuit of your fountain must be protected by a 30 mA differential
device. Refer to the NFC 15-100 installation standard in force.
An HO7RN-8F type sealed flexible cable must be used. These spotlights must
be immersed before use.
PR 15157 and PR 12257 operate only with a safety transformer.
III - MAINTENANCE AND SPARE PARTS
When changing a bulb, the two O-rings guaranteeing the spotlight's leak tightness must
be replaced.
For spotlight maintenance, refer to the table below for the references of the spare parts to
2
be ordered :
1
Item
1/2/3
4/6
7
14/15/16*
3
8*
9
4
10/11/12/13
1/2/11/12/13/15/16
5
6
Item
Designation
1
Clamping screw of retainer ring M5x35
7
2
Clamping screw for color cap M4x8
3
Retainer ring
4
Upper O-ring
5
PAR38 bulb
6
Lower O-ring
7
Body
8*
E27 porcelain socket
9
Cable glands
10
Base
9
11
Base clamping screw M6
12
Washer M6
13
Nut M6
14*
Groung wire
15*
Ground wire clamping screw M4
16*
Washer M4
1, av. des trois peuples 78180 Montigny-le-Bretonneux FRANCE
Reference
Designation
PPR0203
Retainer ring with screws
PPR2101
O-ring set
PPR0104
Unequipped body
PPR1102
Ground wire with screws
PPR1301
E27 porcelain socket
PPR1201
Complete cable gland, set of 2 with seal
PPR0303
Base with screws
PPR5001
Complete set of screws
IV - PARTS LIST
Ajutages
ozzles
Qty
4
3
1
1
1
1
1
1
2
1
1
1
1
1
1
1
AQUAPRISM

Publicité

loading

Ce manuel est également adapté pour:

Aquaprism prb12257Aquaprism prb180Aquaprism prb15157