Publicité
Les langues disponibles
Les langues disponibles
Installation at 4mm air gap
(routing with drill jig 21728; dimension X of the table is reduced by 8 mm)
1
1
Mark start
and end marking
frame.
Move the jig to the right, place on the internal edge
2
on mark
and expand the routing.
Installation on the sash
Corner support PVC
41
* Insert packer for the turn restrictor (item no. 40456) into the
fittings groove corner and screw jointly together with the
mounting bracket.
This document is constantly being edited. The current version
can be found at
https://www.maco.eu/assets/750304
or scan the QR code.
2
2
for the jig on the
2
*
1
Place the internal edge of the jig on mark
jig and rout with guide-ring Ø 27 mm and routing
cutter Ø 16 mm.
249
3
4
Install the restrictor flush up front of the frame
3
rebate in routing
. The angled screw holes
must point to the rear.
Rebated corner support AS / DT / PVC
41
* *
* Fix the mounting bracket with screw M4 (item no. 104548).
** Use screw M5 (item no. 101655) instead of the window
construction screw when manufacturing half round and
angled windows. This screw has to be ordered separately!
1
. Fix the
X
4
*
Created: 09/2006 - Changed: 03/2017
Order No. 750304
All rights and modifications reserved.
Publicité
