PSI Woodworking Products Begleri Skill Toy Kit Traduction Des Instructions D'origine

#PKBEGLERI
Begleri Skill Toy Kit
Kit Features:
• Popular & fun skill toy
• Easy to Turn with Straight Tubes
• Minimal Parts--easy to assemble
• Customizeable Sizes
Required Accessories:
• 7mm Pen Mandrel
• Drill Bit: #PK PK-8MMSG OR #PKPARK-8MM (Brad PT) • Drill Bit: #PK PK-8MMSG OR #PKPARK-8MM (Brad PT)
• Bushing Set (3 pc): #PKBEGBU
• Barrel Trimming set: #PKTRIM734
• Live Tailstock or Mandrel Saver
• 2-part Epoxy or Thick CA (Cyanoacrylate) Glue
• Blank Minimum Size: 7/8" x 7/8" x 2"
Recommended accessories:
• Digital Caliper
• 1/16" tenon tool #LCTEN for "O" ring grooves (optional)
• Small lighter
(to seal ends of cord after cutting)
• 3/32" punch rod or Paper Clip to thread cord
• Small Digital Scale (Optional)
Threaded End Caps
Threaded Tubes
Preparing the Blank:
• Cut blank to the length of the tube, adding 1/16" for squaring off.
• Drill 8MM hole lengthwise through the blank.
• Spread glue over tube, insert the tube into the blank with a twisting motion to spread the glue evenly inside.
• Center the tube lengthwise inside the blank.
• When the glue is dry, square the ends of the blanks, making sure the trimmed ends are 90º to the tube. Use a 7mm
barrel trimmer (MUST USE ¾" TRIM HEAD), or a pen blank squaring jig on a disc sander. Take the excess material
down fl ush to the ends of the tubes. Do not trim past the end of the tube since this may interfere with the threading
and assembly. Use a barrel trimmer to clean the inside of the tube.
DIAGRAM A / PARTS LAYOUT
Paracord
Threaded Tubes
Stopper Nuts
PSI Woodworking Products
O-Rings for
optional style optional style
O-Rings Style
10" 330 DE-CORED
PARACORD PARACORD
10" 275 PARACORD 10" 275 PARACORD