Sauder 413073 Mode D'emploi page 8

5 5
This hole should
be closer to the
BOTTOM (D).
F
D
Carefully turn your unit over onto its front edges. Lay a BACK (F) over one side of your unit.
Make equal margins along all four edges of the BACK (F). Push on opposite corners of your unit if needed to make it "square".
Fasten the BACK (F) to your unit using the NAILS (S).
Repeat this step to fasten the other BACK (F).
NOTE: Perforations have been provided for access through the BACKS. Carefully cut out the holes needed.
Page 8
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Unfi nished edge
NAIL
(32 used in this step)
www.sauder.com/services
S
This hole should
be closer to the
BOTTOM (D).
F
D
413073