Automatic Update Of The Drivers; Updating Or Deinstalling The Driver Version - WIKA USB6200 Mode D'emploi

5. Installation
The current interface driver can be found on our website www.wika.com

5.2 Automatic update of the drivers

An older driver that was previously installed in the system will not be automatically
updated.
To update a driver, the current version must be installed again as described in chapter
5.3 "Updating or deinstalling the driver
When the USB device is plugged in, it is then installed on your PC with the latest driver.
During installation, the previously set COM port may be changed.

5.3 Updating or deinstalling the driver version

In order to update a driver, the "old" driver must first be uninstalled and then the new
driver installed.
5.3.1 Deinstalling the driver
1. Disconnect the connections to USB adapter.
2. Call up the item Software.
⇒
Start \ Settings \ System control
3. Open the sub-item Connections (COM and LPT).
4. Find the entry CP210X USB to UART Bridge Controller in the program list.
5. Press [Change/Remove].
6. Confirm the uninstall warning.
⇒
The uninstallation is now carried out.
7. Then acknowledge the corresponding success message.
⇒
The driver is thus deinstalled for all respective USB adapters.
5.3.2 Reinstallation of the driver
▶
The reinstallation is carried out in line with the installation instructions, see chapter
5.1 "Installing the
WIKA operating instructions, model USB6200
version".
drivers".
EN
13