Table des Matières
Publicité
10
10
The hole should be here
NAIL
(22 used in this step)
Carefully turn your unit over onto its front edges. Lay the BACK (I) over your unit.
Make equal margins along all four edges of the BACK (I). Push on opposite corners of your unit if needed to make it "square".
Fasten the BACK (I) to your unit using the NAILS (ZZ).
NOTE: Perforations have been provided for access through the BACK. Carefully cut out the holes needed.
413072
I
ZZ
www.sauder.com/services
Caution
Do not stand the unit upright without the
BACK fastened. The unit may collapse.
Page 15
Publicité
Table des Matières
