Care And Maintenance; Replacing The Remote Control Battery - Bose Acoustic Wave II Notice D'utilisation

Replacing the remote control battery

Figure 10
Remote control battery
replacement
If your remote control does not work properly, or its range of operation is reduced, it is time to
replace the battery. Follow the instructions below:
1. Place the remote control face down on a flat surface.
2. Using your finger, push the tab lock to the side as shown and hold (Figure 10a). Slide the
battery compartment open.
3. Keeping the remote control face down, insert the new battery into the compartment with
the + symbol facing up (Figure 10b).
4. Gently slide the battery compartment closed. It locks automatically.
(a)
WARNING: Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type. Replace only with a lithium CR2032 or DL2032 3-volt battery by Duracell,
Eveready, Energizer, Maxell, New Sun, or Toshiba (available from most electronics stores).
WARNING: Mishandling the remote control battery may cause a fire or chemical burn. Keep
the battery away from children. Do not recharge, disassemble, heat above 212 °F (100 °C), or
incinerate the battery. Dispose of the used battery promptly and responsibly.
For more information, call Bose
back cover of this guide.

Care and Maintenance

(b)
Tab
® Customer Service. Refer to the phone numbers on the inside
Positive
symbol
13