Troubleshooting - Volfoni ACTIVEYES PRO VBAE-01000 Guide D'utilisation

Monitoring Active and Passive 3D at once
You can watch passive 3D even with the ActivMe Pro
plugged and active. This allows you to monitor 3D on active
and passive displays at once without switching between two
pairs of 3D glasses. Note that the light efficiency in this mode
is lower than exclusively passive 3D.
Product Registration and Software Update
When registering your product online (www.volfoni.com),
you will be entitled to download new software for your
ActivMe Pro device, extending the compatibility to new IR
protocols and standards.
Using your ActivEyes in RF 3D mode
RF communication offers interference-free synchronization
for 3D Glasses. For users who want to use RF, ActivMe Pro can
receive a signal from Volfoni ActivHub Pro. More information
is available at www.volfoni.com
The ActivMe Pro receiver is not compatible with RF4CE,
Zigbee and Bluetooth protocols, or proprietary RF implemen-
tations like Nvidia 3D Vision Pro.

7. TROUBLESHOOTING

If your glasses do not operate, the most common causes are :
PROBLEM
The jack plug may not be all the
way inserted in the ActiveMe Pro
or in the glasses
The IR signal is not recognized
The IR signal is obscured
The IR signal is scrambled by other
sources like direct sunlight
The ActivMe Pro battery is discharged
Your 3D display uses an IR protocol
not compatible with Activeyes Pro
(VPAE-0100-H only)
SOLUTION
Check the connection jack
Check that your 3D system
is emitting IR
Make sure ActivMe Pro is
facing the IR emitter
Reduce external light
Plug the USB cable into a
power source and try again
Check www.volfoni.com
for update
5.