Construction Features; Technical Features; Components Description - RBM MG1 Installation


Cartridge body:

Filter cap:

Filtering cartridge:

Hydraulic seals:

Magnet:
B (MaxT) / B (RoomT)* < 1%
Tested according to IEC 60404-5 & ASTM A977 regulations

Ball valve body:

Swivel fitting:

Compatible fluid:

Max. operating pressure:

Operating temperature:

Degree of filtration:

Noise induced (according to EN13443 and UNI 3822)
The noise induced by MG1 in the piping is 0 dB(A).
As specified in EN 13443 regulation, MG1 belongs to the I group, as well as all other products having noise levels < 20 dB(A).
Configuration 1
* Value with accessory ball valve installed code 3174.05.20
Swivel connection:
enables to easily connect
the filter to connection G
3/4" M of the boiler.
Threaded connections G
3/4": The design choice to
make all the threaded
connections of the main
body of the same
dimensions, allows for an
extreme installation
versatility. For further
information, please see the
"INSTALLATION" section
on this data sheet.
Ball isolating valve: By
intercepting it, it is possible
to perform filter cleaning
operations easily.
Technical Sheet CT3070.0-EN_02

CONSTRUCTION FEATURES

(where MaxT = 130°C, RoomT = 21°C)

TECHNICAL FEATURES

DIMENSIONAL FEATURES
Configuration 2

COMPONENTS DESCRIPTION

It
Polyamide PA66 +30% FV
Polyamide PA66 +30% FV
AISI 304
EPDM PEROX
Neodymium REN35 B = 11.000 Gauss
Brass
Brass
Water, water + glycol
3 Bar
0÷90°C
800 μm
Configuration 3
Seal o-ring.
Safety drain cap: By removing it, it is possible to drain the fluid
from the main body of the filter and to perform programmed
cleaning operations, after intercepting the ball valve.
Note: It is advised that the boiler is off and the system is allowed to
cool at a room temperature before carrying out any maintenance
intervention, in order to avoid burns.
RBM
Configuration 4a / 4b
Closure filter cap.
Magnet protection conduit,
removable.
Stainless steel filtering mesh.
Seal o-ring.
Page 2 of 5