Publicité
Les langues disponibles
Les langues disponibles
6.
Insert a pin through the each of the three (3) holes in the hood protector above the grill and into a mounting clip. See
illustration #2 – Step 6.
7.
Center the protector on the hood and rest it on the bumpons and mounting clips.
Peel and fold three (3) abrasion pads in half over the edge of the hood under the three (3) mounting clips. See illustration #2 –
8.
Step 8.
9. a) Starting with the middle location, insert a screw through an "L" bracket and into each of the three (3) mounting clips. See
illustration #2 – Step 9a.
b) Ensure all components are properly seated together and that the protector is centered on the hood. Tighten the screws into the
mounting clips. See illustration #2, step 9b.
7.
Repeat steps #6, 8, 9a and 9b for the remaining four (4) holes over the headlights.
8.
On some vehicles it may be necessary to adjust the hood bumpers and/or latch for proper clearance.
NOTE: Do not pull on the protector when opening or closing the hood.
Clean the protector with a either a mild soap/water solution or utilize a plastic cleaner. Do not use chemicals or solvents.
Periodically check to make sure the bumpons are in place and that the protector is secure. Avoid using automatic car washes.
Step #6
Thank you for purchasing a hood protector. Retain this sheet for care instructions and kit information.
Step #8
Step #9a
Step #9b
Rev1.July 15, 2016
Publicité
