ledscom LC-L-201 Instructions De Montage page 5

1. The surface for mounting the luminaire
must be level. Use the holes provided for
the screws on the lamp socket to mark the
drill holes.
2. Drill two holes (hole spacing 50 mm) in
the wall according to your marking. Sink
suitable dowels in the holes and make sure
that they are flush with the wall.
3. Now align the lamp holder with the drill
holes and screw it on hand-tight with two
screws.
4. Now screw the upper part onto the
socket and tighten it hand-tight.
5. The installation is now complete. To put
the lamp into operation, choose any E27
bulb and insert it into the porcelain socket.
Subject to technical changes
LEDs Com GmbH, Dohrweg 2a, D-41066 Mönchengladbach, www.leds-com.de, Tel. +49 (0) 2161 - 5 75 99 76
English
Figure 1
Wall lamp (LC-L-201) - Assembly instructions
01/2023