GAMCO DR-5120 Mode D'emploi page 4

Installation
1. Disconnect the power source.
2. Using Table 2 to determine the recommended mounting height, select a mounting location for the hand dryer where no reflective
surfaces or objects (such as a hand basin) are directly under the infra-red sensor eye. The infra-red sensor eye is visible from the
bottom of the dryer. The minimum mounting distance from bottom of the dryer to a reflective surface is 18" (46 cm). When two or
more dryers are installed, they should be spaced apart 24" (61 cm)
3. Use the security hex key supplied to turn the cover mounting screws clockwise to remove the cover from the dryer.
4. Using the mounting template provided, mark locations for the 4 mounting bolt holes on the wall.
5. Fasten the base to the wall, using the type of bolts recommended in Table 3
6. Each dryer must have its own dedicated circuit.
7. Connect the dryer to the nearest suitable distribution panel.
8. Replace cover, turn screws counter-clockwise making certain not to over-tighten.
IMPORTANT:
Consult local and general regulations before performing dryer installation. Ensure the electrical network is
not overloaded. Always connect to a dedicated branch circuit with circuit breaker or fuse protection and an electrical rating
greater than the model hand dryer's rated amperage shown in Table 1 - Electrical Specifications in accordance with the
NEC (National Electrical Code) and/or CEC (Canadian Electrical Code).
Table 2
Recommended Mounting Heights from Floor to Dryer Bottom Edge
Men's washrooms
Women's washrooms
Children's washrooms, ages 4-7
Children's washrooms, ages 7-10
Children's washrooms, ages 10-13
Children's washrooms, ages 13-17
Handicap Mounting Height
Table 3
Type of Wall
Hollow Tile, Lath, Wall Board or Metal
Cement, Brick, or Tile Covered Cement or Brick
Stud Wall with wood Backing
Adjusting Heating Element Controls
The dryer can be operated with the heating element "ON" or "OFF".
Note: The factory setting for the heating element is "ON".
Form No. DR-5120
68-10219 rev01
Type of Bolt
1/4" (M6) screw Type or Wing Type toggle
Bolts
1/4" (M6) Stud Type Expansion Bolts
No 16 (M8) Wood Screws
Multi Language (rev. 10/9/13) © 2013 Gamco Commercial Restroom Accessories, A Division of Bobrick
4
in. (cm.)
46" (117)
44" (112)
32" (81)
36" (91)
40" (102)
44" (112)
37" (94)
Minimum Bolt Length
Dependent on wall thickness
3" (76mm)
2-3/4" (70mm)
Printed in U.S.A.