Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE
INSTALLING OR OPERATING THIS CONTROL COULD CAUSE PERSONAL
INJURY AND/OR PROPERTY DAMAGE.
•
1 – 789A-751A1 Hot Surface Ignitor
•
1 – Ignitor Mounting Bracket
Ignitor Adapter Harness (use to connect
Ignitor mounting bracket
The 789A-751KT2 is an aftermarket direct
replacement Hot Surface Ignitor Kit. This kit can be
utilized to replace a Silicon Carbide Ignitor (Carrier
Rated Voltage:
120 volts + 10%, -15%, 50/60 Hz.
Cold Resistance:
20 to 100 ohms
0.4 to 1.2 amps at 120 ± 1.0 volts
Current:
8 seconds maximum at 102 ± 1.0 volts
Time to 1796 °F (980 °C):
Ignitor Life:
100,000 cycles at 120 volts under typical
conditions
Agency:
CSA Certified
Note: Internal wires to ignitor connections to withstand
operational temperature of 482 °F (250 °C)
new nitride ignitor with old carbide
furnace connector)
emerson.com/white-rodgers
789A-751KT2
OEM Direct Replacement 120V
Hot Surface Ignitor
INSTALLATION INSTRUCTIONS
•
2 – ½" Sheet Metal Mounting Screws
•
1 – Ignitor Adapter Harness
•
1 – Installation Instructions
789A-751A1 Hot Surface Ignitor
model LH33ZS001 or valid cross reference) with
Silicon Nitride on 40" Carrier/ICP Brand mid-
efficiency furnaces.
PARTS INCLUDED
DESCRIPTION
SPECIFICATIONS
PART NO. 37-7750001
1922
Publicité
Manuels Connexes pour White-Rodgers 789A-751KT2
Sommaire des Matières pour White-Rodgers 789A-751KT2
- Page 1 789A-751A1 Hot Surface Ignitor furnace connector) Ignitor mounting bracket DESCRIPTION The 789A-751KT2 is an aftermarket direct model LH33ZS001 or valid cross reference) with Silicon Nitride on 40” Carrier/ICP Brand mid- replacement Hot Surface Ignitor Kit. This kit can be utilized to replace a Silicon Carbide Ignitor (Carrier efficiency furnaces.
- Page 2 Ignitor mounting bracket Fig. 5: Flame-side view of ignitor in correct position Fig. 6: Gas-side view of ignitor in correct position TECHNICAL SUPPORT: 1-888-725-9797 Emerson and White-Rodgers are trademarks of Emerson Electric Co. ©2019 Emerson Electric Co. emerson.com/white-rodgers All rights reserved.
- Page 3 Support de montage de fournaise en carbure) l’allumeur 789A-751KT2 est une trousse d’allumage à surface modèle LH33ZS001 ou autre correspondance valide) chaude à remplacement direct du marché des pièces avec du nitrure de silicium sur les fournaises à...
- Page 4 Fig. 5 : Vue côté flamme de l’allumeur en position Fig. 6 : Vue côté gaz de l’allumeur en position correcte correcte SOUTIEN TECHNIQUE : 1-888-725-9797 Emerson et White-Rodgers sont des marques de commerce d’Emerson Electric Co. ©2019 Emerson emerson.com/white-rodgers Electric Co. Tous droits réservés.