Publicité
Les langues disponibles
Les langues disponibles
READ INSTRUCTIONS AND REVIEW ALL DIAGRAMS BEFORE INSTALLING THE FIXTURE.
KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE.
10. Use silicone sealant (not
provided) all along the back of
the fixture to ensure the fixture
is sealed tightly against the
surface. Do not seal the bottom
of the fixture. Apply silicone
sealant on the wiring access
holes and mounting screw
heads.
WIRING DIAGRAM
Black (line)
White (Neutral)
LED DRIVER
Green / Yellow
(GRD)
Optional Accessory
Dimming wire
0-10V
Visor Installation (If Applicable)
Visor and Screws
WP4000V01
Installation Instructions for Full Cut-off Wall Pack
WP 4216 / WP 4316 / WP 4226 / WP 4326
Drain Holes
11. Check and ensure the
drain holes located on the
bottom of the fixture are
unblocked.
PRODUCT INFORMATION BULLETIN
Use the drill & knockout template found on the rear housing to match most standard
recessed junction boxes (junction box holes as indicated in image).
For a more secure installation, bolt rear housing to mounting surface using standoff's.
(highlighted in the picture below).
Lead wire
to LED load
Energy Efficient Lighting Limited | www.eelighting.ca | Tel: 1-855-415-8878
12. Installation is complete,
turn the power on.
Installation:
Take out 4 pcs of original screw, then
install the visor with the longer
screws provided.
Standoffs
Holes for junction
box
R200908-1430
Publicité
