Troubleshooting - VINCI Hands Free Citrus Juicer Instructions

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

TROUBLESHOOTING

PROBLEM
POSSIBLE CAUSE
1. The fruit is not cut in halves,
but rather in 3/4
The Lid to the Juicer will not
2. The fruit has an over sized
close or stay closed during use
end (or section that attaches
to the stem)
3. The fruit is over 4.5"
You temporarily lost power, or the
The Juicer stopped working
motor became jammed- if so,
midway through juicing
the reset button will be beeping
and flashing blue
The unit may not be plugged in
I press the juice button, but
nothing happens
or power switch may be off
The Lid will not detach from
You are not sliding down the
the Juice Bowl
Hinge Release Button
www.vincihousewares.com | 888.735.3621 | support@vincihousewares.com
17
SOLUTION
Slice the top of the fruit off to
make a smaller portion
Trim extra rind and oversized
end from the top of the fruit
Use only fruit less than 4.5" in
diameter
Press reset button to return
reamer to home position
Check that plug is securely in
socket and that outlet is
functioning. Check to make
sure power is switched to "on"
Slide down the Hinge Release
Button and remove Lid
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
Sometimes the Juice Bowl spins
The fruit is getting stuck in the
and unlocks when the Reamer
Holding Cone, causing the
is retuning to the down (home)
Juice Bowl to spin when the
position
Reamer reverses direction
If you think there may be an issue with your product, please contact customer support at
888-735-3621 or email support@vincihousewares.com.
www.vincihousewares.com | 888.735.3621 | support@vincihousewares.com
SOLUTION
1) Lower the Juice Spout. The
Juice Bowl cannot rotate when
the Juice Spout is in the down
position.
2) Make sure the fruit being
juiced doesn't have excessively
thick rind.
3) Trim extra rind and the over-
sized ends from the top of the
fruit.
18

Publicité

Table des Matières
loading

Table des Matières