Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
11
11B
11A
11B
11A
11A
11 HOSE CONNECTION TO SPOUT BODY
From underneath sink, push the Center Connector (11A) onto receiving Tube (11B),
until unable to push any further. Pull down on the quick connect housing (11A). If the
housing and the Inner Collet (11C) separate slightly but do not pull off receiving Tube
(11B), the connection is secure.
12
12C
12B
12E
12A
12E
12A
12D
12E
12 HOSE CONNECTION TO VALVE BODY
Slide the End Connectors (12A) with arrow (12D) pointing up onto the Valve Bodies
(12B). Push the End Connectors (12A) all the way up until completely seated. Be
careful not to damage O-Rings (12C). Place Clips (12E) onto End Bodies (12C) to
secure End Connectors (12A).
11B
11C
11A
12C
12B
12D
12A
ENGLISH
13
13B
13A
13 WATER SUPPLY CONNECTIONS
Connect water Supply Lines (13A) to Faucet Inlets (13B). Hot water supply lines go
into left inlet. Cold water supply lines go into right inlet. (Supply lines not included).
Please follow manufacturer's instructions when installing supply lines.
DRAIN BODY INSTALLATION
14
14A
14 POP-UP INSTALLATION
Install and adjust Pop-Up (14A) using separate instructions supplied with the Pop-Up
assembly.
15
15 UNIT START UP
Turn on hot and cold water supplies, and check for leaks above and below the sink.
4
13B
HOT
13A
COLD
Publicité
Table des Matières
