Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Model
This Manual applies to LED Flower Pot:
Specification
Our LED Flower Pot is manufactured to an international standard (IP44) to protect against dust and water. This means
that they can be used outdoor, but not near or in pools, provided that they are used in accordance with this Instruction
Manual. This product is made of white polyethylene.
Ambient temperature for operation:
LED:
Battery:
Remote control battery:
Remote control effective distance:
Charging time:
Operation time:
Charger:
Warning and caution
1. These products and their packaging are not toys, please keep out of reach of children.
The remote control and charger are not waterproof and must be kept in a dry location at all times.
Never charge the product in a pool, water or rain, charge in a dry, indoor location.
This product is not designed to be used in pools or ponds.
Disconnect the charger when not in use.
Do not stand, or jump on this product.
Do not sit on this product if it is cracked or damaged.
8. Keep the product away from chemicals and heat.
9. Do not attempt to open the product and its accessories.
10. Do not put under direct sunlight all the time when not in use.
11. Do not attempt to open the product,if open it by consumer themselves,product will be out of after-sale service.
Operation
Charging your new Product
Charge the product for 6 to 8 hours before using as below steps:
Use the attached adaptor to charge at the bottom "DC charging port" as in below Photo 1.
The charging indicator light (Inside the power button) will turn red to indicate that charging is working.
3. The charging indicator light will turn to green when it is fully charged.
4. Covering the charge cap after it is fully charged.
5. Your LED Flower pot is now ready for use.
-14˚ C to 35˚C
6xRGB LEDs
Lithium Battery (1x3.7V, 2000MAH )
CR2025 (3V)
4-8 meters
6 to 8 hours
4 to 8 hours depends on color mode
Input: AC100-240V
Output: DC7.5V 0.6A (CE/ROHS
approved)
EN
Publicité
Table des Matières
