Little Seeds 4549049LS Manuel D'assemblage page 12

Step 2
Attach E to C and D with
Screw , to C and D.
2.1 The mattress support has three adjustable positions.
Loosen the bolt
Make sure you install all of the bolts
unused adjustable position holes.
2.2 Rotate the bracket to proper
position as illustrated and attach
to POST with
NOTE: Tabs must always be above the
mattress support when installed as
shown in right picture.
Do not install the mattress support up
side down where the 4 edges are above
the wire mesh.
C
www.littleseedskids.com
, .
, and adjust the mattress support level.
,
, .
E
2.3 Please ensure the
label "THIS SIDE UP"
facing upwards.
2.4 Do not remove this
pouch from there!
in any of the
D
NOTE: Please ensure that all the height
adjustment holes are filled with
appropriate bolts after the mattress
support has been removed to the desired
level. Make sure that these bolts are
tightly secured. Number of mattress
support position depends on crib's model.
5
12
5
5
5
D
E
2.5 Tabs on corners of
mattress support should
point up.
4
3
X 12 X 8
4
4
3
X 4